Technology

Condensed aerosol: putting out an electrical fire without pressure or water

A StickerProMaxx contains no pressurized gas and no powder: it holds a solid compound that, once activated, turns into an aerosol of ultra-fine particles. These particles chemically interrupt the combustion reaction.

Close-up of the StickerProMaxx aerosol generator and its heat-sensitive cable

How it works

Three stages, a few seconds

How it works in 3 steps: heat detection, fast activation, extinguishing
  1. Detection. Overheating or a flame brings the heat-sensitive cable to 170 °C (± 10 °C). It reacts within 2 to 4 seconds.
  2. Activation. The cable ignites the generator with no power supply at all: the system works even if the power is off.
  3. Extinguishing. The condensed aerosol fills the closed enclosure and puts out the fire within seconds. The enclosure and nearby equipment are preserved.

Chemical inhibition

What sets it apart from other extinguishing methods

A fire stands on four pillars: fuel, oxygen, heat and a self-sustaining chain reaction. Traditional extinguishers cool, smother or dilute. StickerProMaxx condensed aerosol goes straight for the chain reaction: its particles capture the flame’s free radicals and stop it from within.

  • Immediate chemical action, at the heart of combustion
  • Fire knocked down within seconds, no re-ignition
  • No water, no pressurized gas, no corrosive powder
Chemical inhibition: StickerProMaxx condensed aerosol interrupts the fire's chain reaction, whereas traditional extinguishers cool, smother or dilute
Extinguishing methodPrincipleActivationPressureInstallationResidueMaintenance
StickerProMaxx condensed aerosolChemical inhibition of the chain reactionAutomatic at 170 °C, no power supplyNoneStuck or screwed in place, no pipingUnder 1 g, non-conductiveNone, replace after 5 years
Inert gasLowers the oxygen levelDetection and control panelHigh-pressure cylindersPiping networkNonePeriodic inspections
PowderSmothering and inhibitionUsually manualPressurized tankUnit placed nearbyHeavy, corrosive powderPeriodic inspections

Indicative comparison, for educational purposes.

Composition

Potassium salts30 to 70%
Strontium salts20 to 50%
Organic additives2 to 10%
Resins2 to 15%

Composition protected by a European patent.

Environment and safety

  • ODP = 0: no effect on the ozone layer
  • GWP = 0: no greenhouse effect
  • Non-conductive agent, residue under 1 g, non-toxic
  • ABS V0 housing, 100% recyclable

Common specifications

The same guarantees across all 11 models

ActivationThermal, 170 °C ± 10 °C, via heat-sensitive cable
Fire classesB, C, E, F effective; A limited
Protection ratingIP20, indoor use
Operating temperature-30 °C to +70 °C (-22 °F to +158 °F)
Humidity0 to 98%
Altitudeup to 3,000 m (9,800 ft)
Vibration8 G
MountingAt the top, only above the hazard
Service life6 years maximum from manufacture; replace after 5 years

Compliance and documents

EU type-examination passed, patented, designed and assembled in France

Aerosol generator, category P1 pyrotechnic firefighting device under Directive 2013/29/EU. EU type-examination (Module B) passed with notified body No. 0163 (LOM). Composition protected by a European patent. Designed and assembled in Toulouges, France.

StickerProMaxx generator EU type-examination under Directive 2013/29/EU