Installation

Installing a StickerProMaxx step by step

Installation takes 30 seconds once the panel is open: no wiring, no special tools. You just need to follow a few positioning rules.

Correct installation: the detection cable must cover the full width above the breakers

Electrical safety: always switch off the power at the main breaker before opening a panel or cabinet. If in doubt, call an electrician.

The steps

Six steps

  1. Switch off the power at the breaker or main disconnect.
  2. Open the enclosure: remove the front panel or cover, or open the door.
  3. Clean the mounting surface, preferably with isopropyl alcohol.
  4. Mount it on the ceiling of the enclosure, diffuser facing down, directly above the area to protect, at the maximum height allowed for the model (20 cm for the 04, 65 cm for the Residential range, 90 to 190 cm for Pro and Industrial). Press for 3 to 4 seconds, or fix with two screws.
  5. Lay out the detection cable above the entire fullest row (or above every row), without tight bends, and check that nothing blocks the diffuser.
  6. Close up, switch the power back on and write the installation date on the warranty label.

Golden rule

Positioning rules

  • On the ceiling of the enclosure, only above the hazard
  • Diffuser facing down, never blocked
  • Cable directly above the breakers, across the full width
  • Closed enclosure (0 to 2% ventilation)
  • No modification to the generator or the cable
Step 2: heat is detected by the heat-sensitive cable

Lithium batteries: the generator protects the electrical enclosure; it doesn’t address thermal runaway in a lithium battery.

Single use: after an activation, the generator no longer works and must be replaced. See After an activation.

Accessories

Extending or securing the detection cable

To cover a row wider than the built-in cable, or to detect on every row.

AX-DETECT-ML heat-sensitive detection cable on a reel, sold by the meter, for StickerProMaxx automatic extinguishers

AX-DETECT-ML detection cable

Extension sold by the meter to cover a wider row or detect on every row.

Coming soon

AX-SERIE copper crimp connector for linking StickerProMaxx generators in series

AX-SERIE connector

Copper crimp connector: joins an extension or links several generators in series.

Coming soon

AX-6ADH70 adhesive heat-shrink sleeve to protect StickerProMaxx detection cable joints

AX-6ADH70 sleeve

Heat-shrink sleeve that insulates and protects each crimped joint.

Coming soon

AX-SERTX crimping tool for AX-SERIE connectors on StickerProMaxx detection cable

AX-SERTX crimping tool

The tool designed for AX-SERIE connectors, for a reliable joint.

Coming soon

AX-SERFLEX green 100 mm mounting cable ties, bag of 100, to secure StickerProMaxx detection cable

AX-SERFLEX cable ties

Green 100 mm cable ties, bag of 100, to secure the cable directly above the breakers.

Coming soon

Unsure about installation?

Send us a photo of your open panel and we’ll tell you where to place the generator.