Solution — mobility

Camper van: protecting the living-area electrical box

Splitter, inverter, charger, 12 V fuses: in a van, the electrics fit in a few liters, often under a seat or in a cabinet. The StickerProMaxx sticks on in 30 seconds and withstands road vibration.

  • Vibration resistance 8 G
  • From -30 °C to +70 °C, humidity up to 98%
  • No pressure: nothing to check before you hit the road
  • Compact format, 67 mm
Close-up of the StickerProMaxx aerosol generator and its heat-sensitive cable

170 °C

activation threshold

0

pressure, wiring or maintenance

5 years

warranty and service life

30 s

to install

The risk

A confined space, far from help

While driving or at night, overheating in a living-area electrical box goes unnoticed. The generator triggers on its own at 170 °C, with no power supply, even with the battery disconnected.

Lithium batteries: the StickerProMaxx protects the closed electrical box or cabinet. It doesn’t address thermal runaway in a lithium battery.

Correct installation: the detection cable must cover the full width above the breakers

Which model?

Depending on the size of the box or cabinet

ModelCapacityDetectionMax. volumeMax. mounting heightPrice incl. VAT
StickerProMaxx 088 modules per row, up to 4 rows13 cm30 L65 cmComing soonBuy
StickerProMaxx 1212 modules per row, up to 4 rows23 cm30 L65 cmComing soonBuy
StickerProMaxx 1818 modules per row, up to 4 rows33 cm30 L65 cmComing soonBuy

The volume to consider is that of the closed enclosure containing the electrics (box, compartment or cabinet): 30 liters for the Residential range.

Installation

Positioning the generator correctly

  1. Switch off the power at the main breaker or disconnect, then open the enclosure.
  2. Clean the mounting surface with isopropyl alcohol.
  3. Mount it on the ceiling of the enclosure, diffuser facing down, directly above the area to protect (double-sided adhesive pressed for 3 to 4 seconds, or two screws).
  4. Lay out the detection cable above the fuses, splitter and terminal blocks, secured so it doesn’t flap while driving.
  5. Close up and switch the power back on, then write the installation date on the warranty label.

Frequently asked questions

Can vibration set it off?

No. Activation is purely thermal (170 °C); the generator is rated for 8 G of vibration.

Is cold or heat in the van a problem?

Operating range from -30 °C to +70 °C: a van parked in the sun or in winter stays within range.

Can I use it on a boat?

The principle is the same for a closed enclosure on board; respect the IP20 rating (protected from water spray) and the temperature range.

Find your model in 30 seconds

The selection guide gives you the right model based on your modules or your volume.