Solution — home
Solar and EV charging: protecting the enclosures
The DC and AC boxes of a solar installation and the enclosure of an EV charger carry high currents for hours. A StickerProMaxx in each box puts out a fire at the source.
- DC box, AC box, charger enclosure
- At least a StickerProMaxx 08
- No wiring, no maintenance
- Works from -30 °C to +70 °C (-22 °F to +158 °F)

170 °C
activation threshold
0
pressure, wiring or maintenance
5 years
warranty and service life
30 s
to install
The risk
High currents, often outdoors or in the garage
DC disconnects, surge protectors, charger breakers: these devices heat up under continuous load and age with thermal cycling. One enclosure per device, one generator per enclosure.
Lithium batteries: the StickerProMaxx protects electrical enclosures. It doesn’t address thermal runaway in a lithium battery, which falls under the battery manufacturer’s instructions.

Which model?
The right generator for each enclosure
| Model | Capacity | Detection | Max. volume | Max. mounting height | Price incl. VAT | |
|---|---|---|---|---|---|---|
| StickerProMaxx 08 | 8 modules per row, up to 4 rows | 13 cm | 30 L | 65 cm | Coming soon | Buy |
| StickerProMaxx 12 | 12 modules per row, up to 4 rows | 23 cm | 30 L | 65 cm | Coming soon | Buy |
| StickerProMaxx 18 | 18 modules per row, up to 4 rows | 33 cm | 30 L | 65 cm | Coming soon | Buy |
| StickerProMaxx 125 | enclosure ≤ 600 × 900 mm | 50 cm | 125 L | 90 cm | Coming soon | Buy |
The StickerProMaxx 04 is only for single-row, 4-module enclosures: it isn’t suitable for solar boxes. For a utility room or an inverter cabinet, see the Pro range.
Installation
Positioning the generator correctly
- Switch off the power at the main breaker or disconnect, then open the enclosure.
- Clean the mounting surface with isopropyl alcohol.
- Mount it on the ceiling of the enclosure, diffuser facing down, directly above the area to protect (double-sided adhesive pressed for 3 to 4 seconds, or two screws).
- Lay out the detection cable above all the equipment in the enclosure (disconnect, surge protector, breaker).
- Close up and switch the power back on, then write the installation date on the warranty label.
Frequently asked questions
Do I need a generator in both the DC box and the AC box?
Yes, each closed enclosure is protected separately.
My charger enclosure is outdoors: is that possible?
The generator is IP20: it goes inside a closed enclosure, which protects it from the weather. Operating range from -30 °C to +70 °C.
Does it affect the warranty on my installation?
Installation requires no wiring and no mandatory drilling (adhesive). Still, check your installer’s terms.
Find your model in 30 seconds
The selection guide gives you the right model based on your modules or your volume.
