Support

After an activation: 5 key steps

The generator has done its job: the fire inside the enclosure is out. Here’s how to make the installation safe again.

After an activation: 5 key steps - wait, switch off the power, air out, clean, replace
  1. Wait. Keep the enclosure closed for a few minutes while the aerosol works and the temperature comes down.
  2. Switch off the power. Switch off the main breaker before doing anything, and don’t turn the power back on until it has been checked.
  3. Air out. Open the windows and air out the room before spending time in it.
  4. Clean. Open the enclosure and remove the residue (under 1 g, non-conductive) dry, with a cloth or a vacuum. Have an electrician check the cause of the overheating.
  5. Replace. The generator is single-use: replace it with the same model before putting the installation back into service.

If the fire is not out or smoke is still coming out of the enclosure: leave the premises and call 112 (or your local emergency number).

Notify your insurer if any damage is found: the activated generator and its model number can serve as evidence.

Replace your generator

Same model, same location: protection is restored in 30 seconds.