Residential range

StickerProMaxx 08: the automatic extinguisher for pool and solar enclosures

Stuck to the ceiling of an electrical enclosure with 8 modules per row, it keeps constant watch and puts out a fire on its own within seconds, with no power, no pressure and no maintenance.

  • Pool control box, DC/AC solar box, outbuilding enclosure
  • Up to 8 modules per row, 30 liters, up to 4 rows
  • 13 cm (5 in) of detection cable, installs in 30 seconds
StickerProMaxx 08: automatic aerosol extinguisher with 13 cm detection cable

170 °C

activation threshold

13 cm

detection

30 L

protected volume

5 years

warranty

Which enclosure is it for?

The outdoor enclosures nobody watches

A pool control box at the end of the yard, a solar protection box working all day long: isolated boxes, often damp or hot, where overheating can smolder unnoticed. The StickerProMaxx 08 is the minimum model for these enclosures.

Protecting a pool electrical box with StickerProMaxx

Pool control box

Filter pump, salt chlorinator, lighting: a damp enclosure, often isolated at the end of the yard.

Protecting a DC and AC solar box with a StickerProMaxx generator

DC/AC solar box

Protection boxes at the panel or inverter output, working all day long.

Is it the right model?

Is the 08 right for your panel?

The golden rule: the detection cable must cover the hazard zone, and the enclosure volume must not exceed the generator’s capacity. Choose detection first, volume second.

Example: a 20 cm wide PVC enclosure cannot be effectively protected by the 08: move up to the StickerProMaxx 12 or 18.

The StickerProMaxx 08 is right if…

Enclosure8 modules per row, up to 4 rows (choose based on the fullest row)
Enclosure volume30 liters maximum
Mounting height65 cm (25.6 in) max. from the bottom of the enclosure
Detection13 cm of detection cable
Enclosure ventilation0 to 2% (closed enclosure)
How it works in 3 steps: heat detection, fast activation, extinguishing

How it works

It detects, it activates, it extinguishes

  • Detection. The heat-sensitive cable (13 cm) reacts on contact with the flame, at 170 °C ± 10 °C.
  • Activation. Within 2 to 4 seconds, with no electricity and no human intervention.
  • Extinguishing. A condensed aerosol of potassium and strontium particles fills the enclosure and stops combustion within 2 to 4 s.

No pressurized cylinder, no piping, no battery: the generator stays inert until the day it is needed.

Installation

30 seconds to install, no wiring

Electrical safety. Switch off the power before any work. The supply side of the main breaker, solar panels and batteries may remain live. If in doubt, call an electrician.

  1. Switch off the power at the breaker or main disconnect.
  2. Open the enclosure : remove the front panel or cover, or open the door.
  3. Clean the mounting surface, preferably with isopropyl alcohol.
  4. Mount it on the ceiling of the enclosure, diffuser facing down, directly above the area to protect, no more than 65 cm from the bottom. Press for 3 to 4 seconds (or fix with two screws).
  5. Lay out the detection cable (13 cm) above the entire fullest row, without tight bends, and check that nothing blocks the diffuser.
  6. Close up, switch the power back on and write the installation date on the warranty label.
Correct installation: the detection cable must cover the full width above the breakers

Ceiling mounting only, directly above the area to protect. Avoid any direct heat source.

Why condensed aerosol

Protection you install and forget

No pressure, no maintenance

No hydrostatic testing, no refills: 6-year service life, replace after 5 years.

Made for electrical fires

Non-conductive aerosol, effective on class E (electrical) fires, residue under 1 g, non-corrosive and non-toxic.

Compact and eco-friendly

120 mm long and 21.2 g, 100% recyclable housing, zero impact on the ozone layer and climate (ODP 0, GWP 0).

Residential range

Compare models

The wider the enclosure, the wider the detection must be: choose the detection width first, then the volume.

ModelModulesDetectionVolumeMax. mounting height
StickerProMaxx 044 (1 row)built-in loop · 5 cm30 L20 cm
StickerProMaxx 088 per row13 cm30 L65 cm
StickerProMaxx 1212 per row23 cm30 L65 cm
StickerProMaxx 1818 per row33 cm30 L65 cm
StickerProMaxx 50Mx4 rows of 13135 cm50 L65 cm
Residential range: StickerProMaxx 04, 08, 12 and 18 depending on the number of breakers

Compliance and documents

EU type-examination passed, patented, designed and assembled in France

Aerosol generator, category P1 pyrotechnic firefighting device under Directive 2013/29/EU. EU type-examination (Module B) passed with notified body No. 0163 (LOM). Composition protected by a European patent. Designed and assembled in Toulouges, France.

StickerProMaxx generator EU type-examination under Directive 2013/29/EU

Frequently asked questions

Your questions about the StickerProMaxx 08

Can I install it myself?

Yes. The StickerProMaxx 08 mounts inside the panel in 30 seconds, with no electrical wiring at all. Switch off the power before opening the panel; if in doubt, call an electrician.

My panel has several rows: is the 08 suitable?

Yes, up to 4 rows, provided the fullest row has no more than 8 modules and the enclosure stays under 30 liters. Beyond 8 modules per row, choose the StickerProMaxx 12 or 18.

Does it need maintenance?

No: it is unpressurized and maintenance-free. A simple monthly visual check is enough (housing secure, diffuser clear, detection cable intact), and you replace it after 5 years.

What happens when it activates?

The flame triggers the detection cable at 170 °C: within 2 to 4 seconds, the generator releases a condensed aerosol that puts out the fire inside the enclosure within 2 to 4 s. Then: wait, switch off the power, air out the room, clean the residue (under 1 g, non-corrosive) and replace the device.

Does the aerosol damage electrical equipment?

No. The aerosol is non-conductive and its residue is minimal and non-corrosive: it tackles an electrical (class E) fire without damaging nearby equipment.

Does it replace a fire extinguisher?

No. It automatically protects the inside of a closed enclosure. It doesn’t replace a portable extinguisher for a fire that has spread to the room, or a fire safety system where one is required.

Protect your panel today

Ships within 2 business days from Toulouges, France · delivery to France, the European Union, Switzerland, Norway and the United Kingdom · 5-year warranty.